剪板機控制器的啟動流程
剪板機操控器的發動流程是:發動按鈕被按下,操控電機的接觸器線圈通電,三相異步電想法開端工作,送料機構E將板料C向右推動,當板料觸碰右側的SQ1限位開關時,三相異步電想法休止工作,板料也休止移動;此時,操控壓塊下降的液壓缸的電磁鐵YA1上電,壓塊上限位開關SQ2閉合,壓塊開端下降,遇到下限位開關SQ3時,壓塊將板料壓緊;接著,電磁鐵YA3得電,操控刀具升降的開關SQ4閉合,刀具下降,對待剪板料進行切開,到達預定方位后,板料切開完結;卷板機操控刀具升降的液壓缸電磁鐵YA4通電,刀具上升,回到初始方位,遇到SQ4上限位開關時,休止上升;刀具休止復位后,電磁鐵YA2操控壓塊復位,上升到初始方位;通過光電檢測開關檢測已經剪切的板料是否被取走,假設取走,開端下一輪新的切開,假設沒有,剪板機將繼承處于等候的狀態,直至板料被取走,才能夠開端新的工作。

The starting process of the controller of the shearing machine is as follows: the start button is pressed, the contactor coil controlling the motor is energized, the three-phase asynchronous electric idea starts working, the feeding mechanism E pushes the plate C to the right, when the plate touches the SQ1 limit switch on the right, the three-phase asynchronous electric idea stops working and the plate stops moving. At this time, the electromagnet YA1 of the hydraulic cylinder controlling the drop of the press is electrized. The upper limit switch SQ2 of the press is closed, and the start of the press is lowered. When the lower limit switch SQ3 is encountered, the press will press the plate. Then, the electromagnet YA3 gets electricity, control the switch SQ4 of the cutter lifting to close, the cutter drops, treat the shear plate cutting, reach the predetermined position, the plate cutting end; The hydraulic cylinder electromagnet YA4, which controls the lifting of the cutter, is energized. The cutter rises and returns to the initial position. When SQ4 upper limit switch is encountered, it stops rising. After resetting the tool, electromagnet YA2 controls the pressing block to reset and rise to the initial position. Through the photoelectric detection switch to detect whether the shear plate has been removed, assuming that the removal, start the next round of new cutting, assuming that no, the shear machine will continue to be in a waiting state, until the plate is removed, can start a new work.
- 上一篇:液壓剪板機蓄能器節能回路作用 2019/11/11
- 下一篇:剪板機廠家回應自動控制系統的設計 2019/8/20